Turf Master Temporary Grass Marking Paint 500g Dy-Mark’s Turf Master is a quick drying marking paint designed for temporary application to grass – without killing the roots. Turf Master is ideal for a range of applications including landscaping, sporting grounds and golf courses. * Quick dry, toluene-free formula * Low toxicity formula does not damage grass * Ideal for landscaping and sporting grounds * Designed for use with the Dy-Mark Line Master * Also suitable for use by hand Preparation Shake can for at least 20 seconds after the mixing ball begins to rattle. Application Insert can into the Line Master Spot Marking Handle. To achieve the narrowest line width, the spot marking handle must be inserted into the lowest position. Line width can be increased by raising handle in slot. Line width ranges between approx. 60mm and 100mm. Test line width by marking cardboard until desired width is achieved. Masking wheels are designed to sharpen line edges by catching any overspray at the edges only. Removal Turf Master can be removed with the use of water, a stiff brush and detergent. TECHNICAL DATA Size: 500g Aerosol Finish: Matt Colour: White Consistency: Liquid Coverage: 80 – 100 metres of line per aerosol can (depending on line width) Suitable Surfaces: Grass Drying Time: 10 minutes at 25°C Ideal Application Temperature: Between 5°C and 40°C STORAGE Store below 50°C. Do not store in direct sunlight or in vehicles under hot conditions. Protect aerosol cans against physical damage. DISPOSAL Aerosol should be completely emptied prior to disposal. Contents of can are under pressure. Do not puncture or incinerate even when empty. When empty, dispose of this container through an approved recycling scheme or seek advice from your local council regarding accepted disposal methods. SAFETY INFORMATION HIGHLY FLAMMABLE Keep away from flame, heat and sources of ignition. Do not smoke and ensure adequate ventilation during use. Can be harmful by inhalation, in contact with skin and if swallowed. Intentional misuse by deliberately inhaling contents can be harmful or fatal. Please note that the slip resistance and performance of this product depends on many factors outside the control of Dy-Mark; including surface preparation, correct application and environmental conditions. Dy-Mark recommends a risk assessment prior to use to determine if the product is suitable to the: ? Slip resistance required ? Surface type ? Volume of traffic ? Potential exposure to any surface contaminants e.g. water, solvents or chemicals KEEP AWAY FROM CHILDREN
Paint Marker P10 Medium Bullet Tip Black
High performance paint marker
Xylene-free, fast dry formula
Replaceable, heavy duty tips
Bold, easy to read marks
Pen dimensions: 142 x 14mm
Mark Width: 2mm
Contents: 10cc fast drying, Xylene-free paint
Paint Marker P20 Reversible Bullet/Chisel Tip 12072002 RED
High performance paint marker
Xylene-free, fast dry formula
Replaceable, heavy duty and reversible tips
Bold, easy to read marks
Pen dimensions: 135 x 16mm
Mark Width: Chisel Tip 4mm, Bullet Tip 2mm
Contents: 13cc fast drying, Xylene free paint
Paint Marker P30 Broad Chisel Tip 12073005 Yellow
High performance marker
Xylene-free, fast dry formula
Replaceable, heavy duty tips
Bold, easy to read marks
Industrial Marker Duo Permanent Ink 12091001 Black
Permanent ink marker suitable for surfaces that need an indelible mark
Xylene-free, fast-dry formula
Reversible bullet/chisel tip
Suitable for marking on wood, plastics, metals and cardboard
Aluminium shell with airtight cap
Pen dimensions: 135 x 16mm
Mark Width: Chisel Tip – 4mm, Bullet Tip – 2mm
Contents: 13cc permanent, smear resistant ink
Available in RED,BLUE,YELLOW,GREEN, BLACK & WHITE A lead and Xylene free resin based marking paint, used for marking in car parks, tennis courts, factories, warehouses, schools, garage forecourts etc. These paints produce a hard wearing, fast drying line and can be used on concrete, tarmacadam, wood and composites. State: Aerosol Colour: White Odour: Characteristic odour Oxidising: Non-oxidising (by EC criteria) Solubility in water: Insoluble Flammability limits %: lower: 0.8 upper: 18.6 Flash point°C: -10
3M™ T270GA Oil Sorbent Boom 20cm x 5M Absorbency 220L
Booms are typically used to encircle spills and to contain leaks for controlling, cleaning up and recovering oil and petroleum based liquids from effluent discharge, streams, ponds, lakes, rivers and other bodies of water.
Features and Benefits include:
• Hydrophobic
• Cost-effective as oil, not water, is recovered
1MM8 AQUAFLOAT SUPERIOR JACKET LARGE Style 1MM8A2N07 Red/Navy
Inherent buoyancy in excess of 50 Newton
Provides a degree of thermal protection against cold water shock and delays hypothermia upon immersion
Fully waterproof outer fabric / Retroreflective tape on hood, upper arms andwrists
High-visibility yellow adjustable insulated peaked hood, with built-in chin and face protection stored into
collar
Storm flap and extra protective chin strap with touch and close fastening
Chest pockets with water repellent flaps and marine grade whistle
New transparent ID pocket on the chest
Two lower hip pockets with fleece hand warmer
Inner adjustable neoprene wrist seals
Reinforcement panels added to seat area
Draw cord in hem with toggles
Crutch strap for wearer’s safety
New style badging including noms displayed on left arm strap
Antiflushing straps to arms including new easy grip pull tabs
PRODUCT STANDARDS:
ENV 343 1998 - Protection against FOUL WEATHER CONDITIONS rain, wind and cold at temperatures higher than -5°C
EN 393 1993 - 50N BUOYANCY AIDS- Have a buoyancy of no less than 50 Newton for the average adult. They are intended for use in sheltered waters where more bulky or buoyant devices would impair the user’s activity or actually endanger the user, and when help is close at hand and the user is a conscious, competent swimmer.
BUOYANCY LEVEL: 50N
Specification Document Mullion Aquafloat Superior Jacket
1MQ3 AQUAFLOAT SUPERIOR TROUSERS LARGE Style 1MQ3A2N07 Red/Navy
Inherent buoyancy in the form of 100 % closed cellfoam
Fully waterproof / Reinforcements on knees and seat
2 hip pockets with water-repellent flaps
Leg zips for ease of donning over boots
Anti-flushing straps to legs including new easy grip pull tabs
New style badging
Adjustable elastic shoulder braces
PRODUCT STANDARDS:
EN 343 Class 3-1 - PERSONAL PROTECTIVE EQUIPMENT - Protection against FOUL WEATHER CONDITIONS
EN 393: 50N BUOYANCY AIDS - Have a buoyancy of no less than 50 Newton for the average adult. They are intended for use in sheltered waters where more bulky or buoyant devices would impair the user’s activity or actually endanger the user, and when help is close at hand and the user is a conscious, competent swimmer.
2MS1 HI-RISE 275N double chamber Life Jacket - 2MS1A3N06: automatic cellulose cartridge UM RED
State of the art SOLAS 275 Newton inflatable life jacket developed according to the new SOLAS legislation MSC 200 (80) + MSC 207 (81) + ISO 12402
Double chamber inflatable 275N life jacket
Bi-colour cover with reflective silver piping in the front
Zip fastening cover
Marine grade stainless steel D-ring in front to attach safety line
Crutch strap
Marine grade whistle
Buddy line
SOLAS retro-reflective tape
Automatic water-activated SOLAS light
Colour Red
PRODUCT STANDARDS:
SOLAS/MED Recognition that the equipment fully complies with the requirements of the MED (Marine Equipment Directive) will be denoted by a ‘Ships Steering Wheel’ which must be on all equipment sold to European Community Ships of 500 tons or more in size.In addition, material testing and mechanical tests are done, requirements on colour & retro-reflective material, the presence of specified trimmings is checked: a whistle, light,… and further performance tests on the whole garment or device e.g. the capabilities of donning, floatation, righting, etc. The head should be supported at the side and at the back so the airways are well out of the water (the mouth should be 12 cm higher than the water surface). The torso should be leaning backwards at an angle between 30° and 90° (vs. vertical) A ‘relaxed’ (unconscious) person face down in the water should be automatically turned on to his back within 10 seconds (EN 395) and within 5 seconds (EN 396, EN 399).
EN ISO 12402 - 2: 275N LIFE JACKETS Have buoyancy of no less than 275 Newton for the average adult and are intended for use offshore in extreme conditions, when heavy protective clothing is used, or loads such as tool belts are being carried.
3MV7 COMPACT 150N SINGLE CHAMBER RED
Newly developed very compact inflatable lifejacket conforming to ISO 12402 - 150N inflatable lifejacket
High abrasion resistant outer cover with durable wipe clean PVC reinforcement for heavy duty use
Quick burst zip opening / Inflation system operational readiness indicator window on the back
Service date information window on the back
Crutch strap
Marine grade whistle
SOLAS reflective tape
PRODUCT STANDARDS:EN ISO 12402 - 3: 150N LIFE JACKETS - Have buoyancy of no less than 150 Newton for the average adult and are intended for use offshore, or when foul weather clothing is used.
BUOYANCY LEVEL: 150N
No product files are currently available for this product.