Tel: 00353 402 32116

Product Detail

< Back

Spray & Mark U 40013505 Yellow*
Supplier Code: 18MM555
Ex VAT €4.83 EACH

Spray & Mark 400135Marking Out Paint - Inverted - 350g
Dy-Mark’s Spray & Mark is a premium marking out paint designed for a range of applications, including construction,landscaping, civil works and surveying. Spray & Mark is suitable for use with the Long Arm Handle and 2 wheel Spot Marking Handle, also available from Dy-Mark.
* Toluene-free formula
* High opacity, high quality, true colour pigment loading
* Unique spray pattern specifically designed for spot marking as well as "writing" applications
Shake can for at least 20 seconds after the mixing ball begins to rattle.

Hold can in the inverted position, approximately 15 – 20cm from surface. Spray thickness can be adjusted by moving closer or further away from the surface to be sprayed.

Size: 350g Aerosol
Finish: Matt
Colour: Red, Blue, Yellow, White, Fluoro Green, Fluoro Pink, Fluoro Orange
Consistency: Liquid
Coverage: Will produce 200 ‘X’ marks, 80 - 100m in a 50mm continuous line, or cover 4 - 6 sqm
Suitable Surfaces: Concrete, bitumen, grass, rock, steel, timber and general broken ground
Drying Time: 5 minutes at 25°C
Ideal Application Temperature: Between 10°C and 40°C
Store below 50°C. Do not store in direct sunlight or in vehicles under hot conditions. Protect aerosol cans against physical damage.
Aerosol should be completely emptied prior to disposal. Contents of can are under pressure. Do not puncture or incinerate even when empty. When empty, dispose of this container through an approved recycling scheme or seek advice from your local council regarding accepted disposal methods. SAFETY INFORMATION HIGHLY FLAMMABLE
Keep away from flame, heat and sources of ignition. Do not smoke and ensure adequate ventilation during use. Can be harmful by inhalation, in contact with skin and if swallowed. Intentional misuse by deliberately inhaling contents can be harmful or fatal. Please note that the slip resistance and performance of this product depends on many factors outside the control of Dy-Mark; including surface preparation, correct application and environmental conditions.
Dy-Mark recommends a risk assessment prior to use to determine if the product is suitable to the:
* Slip resistance required
* Surface type
* Volume of traffic
* Potential exposure to any surface contaminants e.g. water, solvents or chemicals KEEP AWAY FROM CHILDREN



Follow us