Spray Writer 370235 Forestry & Plantation Marking Paint - 350g
Dy-Mark’s Spray Writer is a reduced toxicity spray for all natural and cut timber applications. With reduced spray drift and low odour this convenient 360° marker is ideal for the forestry and timber processing industries. Spray Writer is also suitable for use in the construction industry.
The product has been formulated to mark wet surfaces without cracking or flaking.
* Toluene-free formula
* Ideal for all natural and cut timber applications
* Will mark wet surfaces without cracking and peeling
* Unique formulation reduces spray drift allowing maximum accuracy of spray pattern
* Ideal for the forestry and timber processing industries
* Also suitable for marking masonry and concrete
Preparation
Shake can for at least 20 seconds after the mixing ball begins to rattle.
Application
Hold can upright or in the inverted position and spray with the nozzle 15 – 20cm from the surface. Adjust the spray pattern by moving closer or further away from surface to be sprayed.
TECHNICAL DATA
Size: 350g Aerosol
Finish: Matt
Colour: 8 Standard and 7 Fluoro Colours
Consistency: Liquid
Coverage: Approximately 2 sqm per can (depending on the surface)
Suitable Surfaces: Natural and cut timber, concrete, masonry, bitumen
Drying Time: 10 minutes at 25°C
Temperature: Between 5°C and 40°C
STORAGE
Store below 50°C. Do not store in direct sunlight or in vehicles under hot conditions. Protect aerosol cans against physical damage.
DISPOSAL
Aerosol should be completely emptied prior to disposal. Contents of can are under pressure. Do not puncture or incinerate even when empty. When empty, dispose of this container through an approved recycling scheme or seek advice from your local council regarding accepted disposal methods.
SAFETY INFORMATION
HIGHLY FLAMMABLE
Keep away from flame, heat and sources of ignition. Do not smoke and ensure adequate ventilation during use. Can be harmful by inhalation, in contact with skin and if swallowed. Intentional misuse by deliberately inhaling contents can be harmful or fatal. Please note that the slip resistance and performance of this product depends on many factors outside the control of Dy-Mark; including surface preparation, correct application and environmental conditions. Dy-Mark recommends a risk assessment prior to use to determine if the product is suitable to the:
* Slip resistance required
* Surface type
* Volume of traffic
* Potential exposure to any surface contaminants e.g. water, solvents or chemicals
KEEP AWAY FROM CHILDREN
Turf Master Temporary Grass Marking Paint 500g
Dy-Mark’s Turf Master is a quick drying marking paint designed for temporary application to grass –
without killing the roots. Turf Master is ideal for a range of applications including landscaping, sporting
grounds and golf courses.
* Quick dry, toluene-free formula
* Low toxicity formula does not damage grass
* Ideal for landscaping and sporting grounds
* Designed for use with the Dy-Mark Line Master
* Also suitable for use by hand (nozzle available separately)
Preparation
Shake can for at least 20 seconds after the mixing ball begins to rattle.
Application
Insert can into the Line Master Spot Marking Handle. To achieve the narrowest line width, the spot
marking handle must be inserted into the lowest position. Line width can be increased by raising handle
in slot. Line width ranges between approx. 60mm and 100mm. Test line width by marking cardboard
until desired width is achieved. Masking wheels are designed to sharpen line edges by catching any
overspray at the edges only.
Removal
Turf Master can be removed with the use of water, a stiff brush and detergent.
TECHNICAL DATA
Size: 500g Aerosol
Finish: Matt
Colour: White
Consistency: Liquid
Coverage: 80 – 100 metres of line per aerosol can (depending on line width)
Suitable Surfaces: Grass
Drying Time: 10 minutes at 25°C
Ideal Application Temperature: Between 5°C and 40°C
STORAGE
Store below 50°C. Do not store in direct sunlight or in vehicles under hot conditions. Protect aerosol cans against physical damage.
DISPOSAL
Aerosol should be completely emptied prior to disposal. Contents of can are under pressure. Do not puncture or incinerate even when empty. When empty, dispose of this container through an approved recycling scheme or seek advice from your local council regarding accepted disposal methods.
SAFETY INFORMATION
HIGHLY FLAMMABLE
Keep away from flame, heat and sources of ignition. Do not smoke and ensure adequate ventilation during use. Can be harmful by inhalation, in contact with skin and if swallowed. Intentional misuse by deliberately inhaling contents can be harmful or fatal.
Please note that the slip resistance and performance of this product depends on many factors outside the control of Dy-Mark; including surface preparation, correct application and environmental conditions.
Dy-Mark recommends a risk assessment prior to use to determine if the product is suitable to the:
? Slip resistance required
? Surface type
? Volume of traffic
? Potential exposure to any surface contaminants e.g. water, solvents or chemicals
KEEP AWAY FROM CHILDREN
No product files are currently available for this product.